Ratio IR1200NM Manual De Instrucciones página 37

2. THE SUPPORT STAND (SEE FIG. B1, B2)
Pull the support stand to its extreme, as shown in Fig.
B1, B2.
WARNING: Always keep the support stand
at its extreme out position when using the
product.
B1
B2
B2
B3
17
3. WORK CLAMP (SEE FIG. C)
1) The work clamp can be fitted on either side of
the saw and is fully adjustable to suit the size of
the workpiece.
2) Do not operate the saw without clamping the
workpiece.
3) Make sure that the work clamp securing
screws are tightened.
C
4. MOUNTING HOLES (SEE FIG. D)
Before use, the saw can be fixed to a firm, level
surface with the 4 mounting bolts (not supplied).
Four holes are provided in the base of the saw
to enable it to be fixed to a bench, or other
supporting surface.
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be
mounted.
2) Drill 4 holes through the surface.
3) Place the sliding miter saw on the surface
aligning holes in base with holes drilled in the
surface. Install bolts, washers and hex nuts.
D
OPERATION
1. RELEASING THE SAW HEAD (SEE FIG. E1, E2)
When boxed or during storage, transportation,
the saw head is locked in the down position.
To release the head ready for operation, apply
downward pressure and pull out the lock pin (a),
The head will be raised gently to upper position..
37