AL-KO AMS2 Guia Del Usuario página 8

en
Pay attention to the +/- mark on the printed circuit board! The red cable is positive (+), the black
ADVICE
cable is negative (-).
3. Insert the battery cable into the housing and screw onto the printed circuit board, tightening toque 0.5
Nm.
Pay attention to the polarity (8)
4. Screw the cable screw connection of the battery cable into the housing, M12 (small). Tightening: into
the housing until the head makes contact.
5. Position the rubber seal and tighten the union nut. Tightening union nut: finger-tight and tighten a fur-
ther 1/4 turn with a spanner.
6. Connect the enable line (CAN bus cable) to the secured plug of the adapter.
Make sure that the plug/socket connection is correctly locked, or it will not work!
ADVICE
7. Remove the transport lock KB adapter CAN/enable.
8. Push the enable line (CAN bus cable) into the drive.
9. Screw the middle cable screw connection into the housing, M 20 (large). Tightening: into the housing
until the head makes contact.
10.Position the rubber seal and tighten the union nut. Tightening union nut: finger-tight and tighten a fur-
ther 1/4 turn with a spanner.
11. Screw the screw plug back in, tightening torque 4 Nm.
12.Connect the battery. IMPORTANT! Do not insert the fuse yet!
13.Connect all disconnected lines and plugs in the caravan.
14.Insert the fuse.
15.Perform a function test.
8
1652108_b