JANE REVOLUTION Manual Del Usuario página 26

EN
2.- HIP CARRYING POSITION SUPPORTED ON YOUR WAIST WITH THE RIGID SEAT
Remember that for this position your child must be able to support the weight of his head unaided and must no longer need the leg insert. Therefore, he should be over five or six months old.
Follow the steps below that are shown in the diagrams on page 8.
STEP 1. If you are going to use the seat for the baby's comfort insert the seat into the front pocket as you did for the previous position.
Separate the body of the baby carrier from the abdominal belt and open the storage pocket (page 4 F) to insert the seat mould. Remember that this mould is not a toy, do not let the child play
with it or fiddle with it. Once the mould is positioned inside the pocket, check that it is rigid enough to support your baby's weight and that the mould is in perfect condition. Reattach the body
of the baby carrier by the zip on the outside edge of the seat.
STEP 2. Put the waist belt or band on. Make sure the buckle clicks to indicate it is securely fastened. Make sure the belt is snug and roll up any surplus strap and secure it with the elastic band.
Keep the leg insert inside the inner pocket to keep it out of the way now you no longer need it.
Now undo the buckles on the shoulder straps of your baby carrier. The straps should hang down parallel to your arms.
STEP 3. Decide which side you want to carry your child on as you will have to put on the strap on the opposite side first to fasten it to the opposite buckle at your waist.
For example, if you want to carry your child on your left hip, fasten the right strap with the buckle on the left side of your waist and vice versa.
STEP 4. Move the baby carrier turning it gently to the hip where you want to carry the child, and pass the strap over your head and shoulders. Now you will have a strap going diagonally across
your back.
STEP 5. Carefully pick your child up and hold him on your free shoulder. Slowly position your child inside the baby carrier facing you and raise the child up to the upper part of your body until
you child is positioned in the middle of the baby carrier, his forehead should be at the height of your chin. Raise the body part of the baby carrier and hold it against your child's back.
Warning: Do not let go of your child and always make sure that he is held safely in your arms.
STEP 6. While holding your child with one hand, (remember that one strap is in place), put the other strap on and pass it to the opposite buckle. Fasten the buckle while your arm holding the
baby slides the child into place on the side of your hip. Check that your child is supported on your hip opposite the side that has the shoulder strap on.
NOTE: Bear in mind that the flap or head pad will offer your child greater comfort. Check that none of your child's extremities have got trapped between the abdominal belt and your waist, or
between the side or shoulder straps.
To place your child in the same position without the seat, follow the same steps above missing out step 1 when the mould is fitted into the central pocket.
3.- BACK CARRYING POSITION WITH THE RIGID SUPPORT SEAT
Remember that for this position your child must be able to support the weight of his head unaided and must no longer need the leg insert. Therefore, he should be over five or six months old.
Follow the steps below that are shown in the diagrams on page 9:
STEP 1. First think about whether it will be more comfortable for your child to use the seat in the front pocket, and if so, follow the steps above to insert the mould into the pocket.
STEP 2. Fasten the abdominal belt and check that the strap buckles of the baby carrier are securely fastened and are parallel to your arms. Loosen the short end of the belt so you can turn it
more easily. For this position leave the straps a little bit longer.
STEP 3. Raise the child up to the upper part of your body so your chin touches his forehead and then gradually position his bottom in the seat making sure that your child is well positioned in
the middle of the seat.
STEP 4. Raise the whole front part of the body of your baby carrier and hold it against your child's back.
STEP 5. Gently turn the whole baby carrier passing it to your back holding onto the baby carrier and your child's body.
STEP 6. With your free hand hold the child while moving your elbow up over the child's head and putting the strap on. Always keep the straps taut so the child remains safely in contact with
the top part of your arm.
STEP 7. Gently push your child a little while using your other hand to gently turn the abdominal belt around. Make sure you keep the straps taut.
STEP 8. Bend down a little keeping your back straight so you can put your other arm through the strap and fasten the buckle on the strap to join them across the front on your chest. And now
you can tighten the short end of the belt.
NOTE: If you do not feel confident or are not sure you are able to put your child in this position by yourself, ask another adult to help you to put your child in the seat of the baby carrier and
hold the carrier while you put the straps on your back and finally fasten the belt across your chest.
To place your child in the same position without the seat, follow the same steps above missing out step 1 when the mould is fitted into the central pocket.
26