Publicidad
ENGLISH
1) PRECAUTIONS FOR USE (The product guarantee depends
onthe respect for these rules)
INSTALLATION and START UP
For products delivered with filters, these must be installed in
accordance with the instructions. Before commissioning any of our
valves, it is essential to carefully drain the pipes that can damage
the mechanisms or water passages. Recommended operating
pressure according to NF EN 816: 1 to 5 bar. CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned
only with soapy water. Abrasive, acid, alkaline or ammonia-based
household products are prohibited.
2) Start up
3) This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and
maintenance shall be made by qualified
staff.
4) For proper operation of the sensor tapware, avoid installing these
product facing a mirror or any other reflective surfaces. Do not install
2 sensor taps facing one another.
5) Basket filter seal included
6) Straight stop valve ref. 29860
7) Automatic rinse
8) Flow rate diagram
9) Flow rate
10) Flow straightener
11) Flow limiter
12) Bar
13) Power supply 230 VAC with cable 2 x 0,5mm² min. Ø 6 to 8,5
mm. Disconnect the supply before any maintenance on the tap. The
transformer is equipped with thermal protection against overload.
In case of operating, disconnect the power supply for 30 seconds,
fix the problem, then turn it back on.
14) Fixing: 2 screws Ø 4.5 max
15)Top
16) Bottom
17)Recommended working pressure: 0,1 Mpa (1 bar) 0,5 Mpa (5
bar). Maximum working pressure: 0,05 Mpa (0,5 bar) - 0,8 Mpa
(8bar). Protection factor IP54.
18) Mixer tap/adjusting antiscalding stop
19) Preset delivery position
20) To release hot water of 40°C +/- 2°C with equal pressure,
place the limiter as shown below.
21) Hot water \ cold water
22) Mixer tap without lever/adjusting antiscalding stop
23) To get water of 40°C, turn the mixer shaft with a
screwdriver following the arrow untill you get the desired
temperature.
24) Taps with regular rince: automatic rinsing of 30
secondes every 72 hours after the last use (and every 72
hours after) to avoid the water stagnation and to prevent the
growth of legionella.
25) MAINTENANCE
26) Replacing the battery ref. 90941
27) DEAD BATTERY
28) The infrared cell blinks, no use possible.
29) Lithium battery 6V CRP2 ref. 90941
30) Replacing the solenoid valve ref. 90944
31) Solenoid valve
32) Replacing the seal
33) Replacing sensor circuit
34) Battery-powered sensor circuit ref. 90942
35) Mains-powered sensor circuit ref. 90943
ITALIANO
1) PRECAUZIONI D'USO (La garanzia del prodotto è
soggetta alrispetto delle presenti norme)
MONTAGGIO e UTILIZZO
Per quanto riguarda i prodotti consegnati completi di filtri,
questi devono essere tassativamente montati in conformità a
quanto riportato sulle istruzioni. Prima della messa in
funzione dei rubinetti,indipendentemente dal tipo, è
indispensabile spurgare accuratamente le tubazioni per
evitare di danneggiare i meccanismi o i passaggi dell'acqua.
Pressione di servizio raccomandata, secondo NF EN 816: da
1 a 5 bar.
PULIZIA
Pulire il rivestimento cromato delle rubinetterie PRESTO®
esclusivamente con acqua saponata. Non utilizzare prodotti
detergenti abrasivi, acidi, alcalini o contenenti ammoniaca.
2) Utilizzo
3) L'apparecchio può essere utilizzato
anche da bambini di età superiore agli
8 anni e da persone con ridotte
capacità psico fisico sensoriali o con
esperienza e conoscenze insufficienti,
purché attentamente sorvegliate e
istruite su come utilizzare in modo
sicuro l'apparecchio e sui pericoli che
7
Publicidad
