Removal Of Integral Filter; Emptying The Machine; Machine Without Drain Pump; Machine With Drain Pump - Elettrobar Niagara 281 Manual De Instrucciones

INSTRUCTION MANUAL FOR DISHWASHERS
1. Turn off the machine.
2. Place the wash and rinse arms at a right angle to the edge
Fig. 5
of the door (
3. Raise each semi-filter, grasping it by the handle.
Turn off the machine.
Remove the integral filter (
Extract the overflow by pulling upwards (
completely.
If necessary, extract the tub filter and clean (
With the machine on (
until the
Remove the integral filter(
Extract the overflow (
Press the START button (3). Machine draining starts and the indicator light flashes.
The machine turns off at the end.
If necessary, extract the tub filter and clean (
•
At the end of the day always drain the machine as described in the "Machine draining" section.
•
Disconnect the power supply by means of the main switch and close the external water
cock.
•
Perform routine maintenance and clean the machine as described in the "Maintenance" section.
•
If possible, leave the door ajar to prevent the formation of unpleasant smells inside.
All manuals and user guides at all-guides.com
).
Fig. 5
).
Fig. 6 C
Fig. 7
), press the PROGRAMME SELECTION button (2)
DRAIN CYCLE indicator light (5) comes on.
Fig. 5
).
Fig. 6 B
).
Fig. 6 C

4.6 Removal of integral filter

4.7 Emptying the machine

4.7.1 Machine without drain pump

Fig. 6 B
), and wait for the tub to drain
).

4.7.2 Machine with drain pump

).
7
GB

4.8 End of service