Canon imageCLASS MF449dw Introducción página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Quick Setup
Configuring the Machine
To connect via wired LAN
The machine does not come with a LAN cable.
Please have one ready, if necessary.
1.
Make sure that the computer is connected to a
router properly.
2.
Check the network settings on the computer.
3.
Connect the LAN cable.
• After connecting the cable, wait a few minutes
(until the IP address is set automatically).
• If a static IP address has been set on the
computer, set the machine's IP address
manually.
4.
Install the driver and software.
P.11 "Installing the software"
En
Now you are finished with the
configuration of the initial settings.
Proceed to configuring the fax
10
settings.
P.12
To connect via USB
• The machine does not come with a USB cable.
Please have one ready, if necessary.
• Make sure that the USB cable you
use has the following mark.
• Do not connect the USB cable before installing
the driver. If you did, disconnect the USB cable
from the computer, close the dialog box, and then
perform the following procedure from step 1.
1.
Install the driver and software.
P.11 "Installing the software"
• When a screen with instructions for
connecting the USB cable to the machine is
displayed, remove the sticker that covers the
USB port.
Now you are finished with the
configuration of the initial settings.
Proceed to configuring the fax
settings.
P.12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Imageclass mf448dwImageclass mf445dw

Tabla de contenido