Setting The Clock; Setting The Alarm(S); Enabling/Disabling The Alarm; Snoozing The Alarm(S) - i-box Dawn Manual Del Usuario

Clock setting
1. Plug in the DC 5V adaptor, the unit will display the default time 0:00.
2. Press and hold
3. Press (2) or
4. Press (7) again to set the hour.
5. Press (2) or
6. Press (7) to set the minute(s.
7. Press (2) or
8. Press (7) to finish once the time has been set.
Alarm setting
1. In standby mode (or clock mode), press and hold
then allow you to set the first alarm.
2. Press (2) or
3. Press (6) and
4. Press (6) and
5. Press (6) and
6. Press (6) and
7. Press (6) and
8. Press (6) again once the alarm(s) has been set to exit.
Alarm enable/disable
1. In standby mode, press
2. The alarm will cycle through: AL1 / AL2 / AL1 and AL2 / off.
Stop & Snooze alarm
When the alarm sounds, press
to delay the alarm for 9 minutes.
Press (8) to turn off the alarm.
Dimmer
Press (5, Snooze) to select the brightness of the display.
07 | Dawn
(7) for 1-2 seconds, the display will then show 24hr.
(4) to switch between 24hr and 12hr time.
(4) to change the hour.
(4) to change the minute(s).
(4) to select the AL1 hour.
/ (2/4) to select the AL1 minute(s).
/ (2/4) again to select the AL1 source (beep or FM).
/ (2/4) to select the AL2 hour.
/ (2/4) to select the AL2 minute(s).
/ (2/4) again to select the AL2 source (beep or FM).
(6) to enable the alarm.
(5, Snooze)
(6) for 3 seconds, the unit will
6:25
Alarm volume
+
Vol: 0-7 40s