Programming The Timer - GE SmartWater GXSS20B Manual Del Propietario Y Instrucciones De Instalación

Display

Programming the Timer

Set the timer:
When the transformer is plugged into electrical outlet, 12:00AM, SUnday will begin to flash in the time display.
Set the time of day and present day of week as follows:
A. Set the time of day:
Press the TIME/DAY button once and the hour display will begin to flash.
1
Press the SET/CLEAR button until the present hour of the day shows in the display. Be sure AM shows
2
for morning hours, or PM for afternoon and evening hours.
NOTE: Press SET/CLEAR button and quickly release to move the hour display ahead 1 at a time to
the correct hour. Or, hold the SET/CLEAR button to move the display ahead 2 hours each second,
to the correct hour.
Press the TIME/DAY button once to steady the hour display, and minutes begin to flash.
3
Repeat Step A. 2 to set the correct minutes.
Press the TIME/DAY button again to steady the minute display (day will begin flashing). Fig. 7 shows
4
the timer set at 3:30 PM.
B. Set the present day of the week:
Press the SET/CLEAR button to set the present day of the week in the display.
1
NOTE: Press SET/CLEAR button and quickly release to move the day display 1 at a time. Or hold the
SET/CLEAR button to move the day display ahead 2 days each second.
Press the TIME/DAY button again to steady the entire display. Fig. 7 shows the timer set at TUesday.
2
No other settings are needed after installing your water softener. The softener is factory set to regenerate
every Monday, Wednesday and Saturday (beginning at 2:00 AM). For most families, this gives enough soft
water for their needs. However, if you want the softener to regenerate at a different time, or on different
days, or to set for the most efficiency, see About the Water Softener System section.
EXAMPLE: This drawing shows the
Fig. 7
present time of day at 3:30 PM,
and the present day on TUesday.
See the Operating section for other
timer controls and features.
9