Stage 2 Base Assembly - Evenflo exer saucer BABY ACTIVE Triple Fun Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Stage 1
Stage 1 is used for infants from birth to approximately 4 months old.
CLICK!
B
Stage 2 is used for infants who can hold up their head and neck unassisted (approximately
Stage 2
4 months old) until they can walk unassisted or exceed 30 inches (76 cm) in height.
D
E
D
F
C
1. Place mat
on floor.
A
2. Place feet
on either side of mat, as shown.
B
3. Install toy bar
into feet, as shown. Press toy bar down
C
firmly until it clicks into place. Pull up on the toy bar and
stalk toys installed into the feet to make sure they are locked
in place.
B
A
1. Locate four lower leg pedestals
F
. Turn over and install the
1-1/2 inch (38 mm) spring
D
with screw
leg pedestal. Position spring as shown. Do not overtighten
screw.
2
Stage 1
F
F1
G
Stage 2
E
in each lower
2. To install a lower leg pedestal
so that the locking tab with the rib
G
over the slot with the notch
F1
G1
G
D
3. Attach the spring
as shown. Once the spring is in place, align all three locking
tabs
F > !
foot and click the lower leg pedestal into place.
CLICK!
G
F
F
4. Check to ensure that the locking tabs are installed properly
by turning the lower leg pedestal
releasing. The lower leg pedestal MUST spring back into
F
place.
Repeat for all four lower leg pedestals.
3

Stage 2 Base Assembly

F
, hold it above the base foot
lines up directly
F > !
G > !
.
G2
to the hook
on the base foot
,
D
G > @
G
on the lower leg pedestal with the slots in the base
clockwise, then
F

Publicidad

Tabla de contenido
loading

Tabla de contenido