Safety Advice - Milomex Z16531 Instrucciones De Utilización Y De Seguridad

Safety advice

Keep all the safety advice and instruc-
tions in a safe place for future refer-
ence!
J Always keep the product out of reach of children.
Children often underestimate danger. Store the
device indoors in an enclosed, dry place where
it cannot be reached by children.
Ensure that staples and nails cannot under any
J
circumstances strike people or animals. Failure
to observe this advice may lead to injury.
J Wear personal protective equipment and always
wear safety glasses. This also applies to people
who may be helping with the work by support-
ing or holding the workpiece.
CAUTION! Do not support yourself with your
hands under any circumstances near or in front
the stapler gun or on the surface being tacked.
One slip may result in injury.
Every time before you use the device, check
J
that it is in perfect condition. Damage to any of
its components may lead to injury.
J Before moving or putting away the stapler gun,
check that there are no staples or nails still in
the device.
Operation
Q
Filling with staples / nails
Q
CAUTION! Use only the staples and nails
described in these operating instructions (see
"Staples / nails"). Failure to observe this advice
may result in damage to the device.
Follow these steps:
1. Press in the staple pusher
pull it downwards. Then pull the staple pusher
completely out of the magazine
2. Push the staples or the T-nails into the maga-
zine .
4
CAUTION! Ensure that the staples or T-nails
are correctly inserted (see Figs. B, C, D).
3. Push the staple pusher
2 slightly and then
2
(see Fig. A).
4
back into the maga-
2
Safety advice / Operation
zine . Press in the staple pusher
4
and then pull it slightly upwards to fix it in place.
Setting the impact force
Q
CAUTION! Never screw the adjusing screw
completely out of the stapler gun. This could result
in damage to the device.
Screw out the adjusing screw
j
the impact force.
j Screw in the adjusing screw
the impact force.
Stapling
Q
CAUTION! Never support yourself by placing
your hands near or in front of the stapler gun or the
workpiece surface. A slip can result in injury.
Follow these steps:
1. Press the staple eject opening
where you wish to staple.
2. Adjust the impact force to suit the materials,
staples or nails.
3. Press the operating lever
Examples of use:
The stapler gun is suitable for the following purposes:
- Attaching coverings to the seating surface of
chairs.
- Attaching a skirting at the joint between wall
and floor coverings.
- Stretching and stapling canvasses to frames.
- Attaching protective films to insulation materials
when installing thermal insulation.
- Attaching decorative materials.
Removing staples
Q
To avoid the risk of injury!
Ensure that the operating handle
j
pressed
j Push the hook under the staple or nail head
3
slightly
2
7
to reduce
7
to increase
7
on the spot
6
1 down firmly.
will not be
1
GB/MT 15