Stagnoli SATURNO-S Manual De Usuario página 20

You can choose between the following operating modes:
1)_time_ : in this mode it is important to pay close attention to the seconds set in order to have the result desired considering that the
installation
will cycle independently ignoring the inputs and following only the times set.
2)_booking_ : In addition to setting the times, it should be considered that the connected accessories will play a decisive role in the correct
operation of the system. Therefore, this mode will not cycle if it does not receive an input and remains in stand-by mode.
3)_combination_ : it is a function which will execute the cycle of the traffic light from which the booking arrived, if present, the cycles of
the 4)_parking_ : it is a function that changes the interface a bit and some of the settings described so far. In this mode you will be able to
decide
whether to assign a single counter to the entire system, which is located in the second box under "parking spots" and from there you can
set the total number of parking spots (free and occupied) that the parking has. In the " Setup " section, on the other hand, each traffic light
can be assigned a total parking spot counter (free and occupied) which, for example, will be dedicated to managing a floor car park or a
certain area. It will be necessary to use two sensors, one wired to input 1 (input) and one wired to input 2 (output) of the slave. The sensor
wired to input 1 will be used to decrease the number of free spots and, vice versa, the sensor wired to input 2 will be used to increase the
number of free spots.
IT
After you have made all the changes you need to save your settings by clicking on the button "Salva".
EN
In this section you can configure everything related to the connection with the terminal (master).
SSID device: name displayed in the list of devices available during the search to establish a connection with the master through a smart device
(PC, tablet, smartphone).
Password device: it is the security key that will be used to keep the connection to the device and consequently the system settings safe.
Channel device: it is the frequency on which the Wi-Fi connection will be established. Leave the default setting.
The remaining settings in this section should not be considered and therefore their respective fields should be left blank.
FR
When changing the parameters click on "Salva" to save the changes made.
ES
If a parking logic has been set on the control unit and a general counter has been assigned for all the traffic lights, the item
" Global free places" will be In this section you can download the system configuration and load a configuration you already have.
DE
Stagnoli recommends that you always create a backup copy of the traffic light configuration in case you need to reset it.
20
WI-FI CONFIGURATION SECTION
SAVE AND RESET SECTION
www.stagnoli.com