Raid Setup Procedure - Monster semruk S7 V8.1 Manual De Usuario

EN

RAID Setup Procedure

1. Start-up your notebook computer and press F2 to enter the BIOS and go to
the Setup Utility.
2. Select the Advanced menu.
3. Select SATA Mode, press Enter and select Intel RST Premium...
and select <OK>.
4. Press F10 to "Save and Exit" and select <Yes>.
5. After the computer restarts press F2 to enter the BIOS again and go to the
Setup Utility.
6. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and select
Create RAID Volume.
7. You can now setup your RAID volume using the installed SSDs.
8. Select Name and type a name of your choice for your RAID volume and
select <Yes>.
9. Select RAID Level and choose the RAID Level required (Table 1) and
press Enter.
• RAID 0 (Stripe)
10. Go to any of the disks listed under Select Disks: and select a disk name.
11. Click on X to select the disk required.
12. You should select two or three identical SSDs to form your RAID volume.
13. If you have selected RAID 0 (Stripe) then you can adjust the Strip Size to
your requirements (It is recommended that you set the "Strip Size"
to 128KB).
14. Select Create Volume (make sure you have selected your disks).
15. The system will list your RAID volume.
16. Press F10 to "Save and Exit" and select <Yes>, however note below.
• Make sure the Windows 10 OS (DVD) is in the attached DVD drive or on a
USB flash drive and as the computer starts up it will automatically boot from
the Windows 10 OS DVD or USB flash drive.
17. Click Next > Install Now to continue installing the operating system as
normal (see your Windows documentation if you need help on installing the
Windows OS).
18. Follow the on-screen instructions to install the Windows 10 operating
system.
19. Install the Windows drivers (see page 26). Make sure you install the
Intel® Rapid Storage Technology (IRST) driver.
10
• RAID 1 (Mirror) • RAID 5 (Parity)