Installing The Optional Febreze Filter; Using The Vacuum - Bissell CLEANVIEW 2831 Serie Manual Del Usuario

Installing the Optional Febreze Filter

Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filter.
1.
To change the filter, turn
OFF machine and remove dirt
tank from the hand vacuum
by pressing the tank release
button and sliding the tank out.
Certain trademarks used under license from The Procter & Gamble Company or its affiliates.

Using the Vacuum

Looking for more guidance? Go to support.BISSELL.com for tips and 24-7 support while
cleaning.
CleanView® Pet Slim Corded can be used as a stick vacuum, hand vacuum or for extended reach with
the hand vacuum and extension wand.
1.
Slide the power switch
down to begin cleaning and
back up to turn the machine
OFF when finished cleaning.
WARNING
4 BISSELL.com
2.
Twist top to remove filter
frame from the separator.
Remove the filter from the
filter frame housing.
2.
Choose your cleaning mode:
Hard Floor Mode
Slide the power switch down
1 notch. This mode is great for
hard floors, low pile carpets
and area rugs and provides a
quieter sound. The brush roll
does not spin in Hard Floor
Mode.
Do not use your vacuum until you are familiar with all instructions and operating procedures.
3.
Replace with the Febreze
filter and reinstall the filter
frame.
Carpet Cleaning Mode
Slide the power switch
down 2 notches. This is
recommended for maximum
suction and provides the most
powerful clean. This mode is
perfect for high, medium and
low pile carpet.