4. Maintenance and care of the appliance
4.1 Overall cleaning
• Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and
energy saving.
• Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft cloth
dampened with soapy water or diluted detergen!.
• The interior of the refrigerator should be cleaned regularly to avoid odor.
• Please turn off the power befare cleaning interior, remove all foods, drinks ,shelves, drawers, etc.
• Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda and
a quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let it dry
naturally befare turning on the power.
• Far areas thal are difficult to clean in !he refrigerator (such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined with
sorne auxiliary tools (such as !hin sticks) to ensure no contaminants or bacterials accumulation in these
areas.
• Do not use soap, detergen!, scrub powder, spray cleaner, etc., as these may cause odors in the interior of
the refrigerator or contaminated food.
• Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted
detergen!. Dry with a soft cloth or dry naturally.
• Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy water, detergen!, etc., and
then wipe dry.
• Do not use hard brushes, clean steel balls, wire brushes, abrasives
(such as toothpastes), organic solvents (such as alcohol, acetone,
banana oil, etc.), boiling water, acid or alkaline ilems, which may
damage the fridge surface and interior. Boiling water and organic
solvents such as benzene may deform or damage plastic parts.
• Do not rinse directly wilh water or other liquids during cleaning to
avoid short circuits or affect electrical insulation after immersion.
A
Ple ase unplug !he refrigerator far defrost and cleaning.
e
4.2 Cleaning the glass shelf
• Remove the drawer on the glass shelf;
• Lifl up the front of glass shelf(about 60
• Remove the glass shelf and clean as needed;
• The reverse operation is far installation of glass shelf.
4.3 How to take out the pearl cotton block inside
humidification shelf components
• The pearl coitan is used to separate !he humidily
conditioning shelf from the moisture-proof cover (to
preven! the moisture-proof cover from falling off during
transportation). After unpacking, !he user needs to remove
this pearl coitan from the moisture-retaining shelf
assembly. Removal method: grip bolh sides of the pearl
coitan by hand and pulls out hard until the pearl coitan
completely leaves the moisturizing shelf assembly.
)
º
), and then pull out;
15
V.1