Publicidad
INTRODUCTION
The BLOCKSYSTEM is a refrigerating set that consists of
one condensing unit, one evaporator and one control
panel. This solution enables to have a product easy to
be installed, with compact overall dimensions and reduced
maintenance costs.
All Blocksystems are equipped as follows:
•
self-bearing housing made of galvanized sheet which
is coated with epoxy powder;
•
panels easy to be removed that guarantee an easy
access to the components in case of inspection or
maintenance;
•
hermetic or semi-hermetic compressors with motor
thermic protection;
•
electronic control board that can be programmed
according to different user requirements;
•
control panel installed in a remote position;
•
heat exchangers with copper and aluminium blocks;
•
condensation by air (optional by water);
•
gas expansion by capillary tube or thermostatic valve;
•
ventilation or heater automatic defrosting with
programmable run duration and frequency;
•
direct condensing water discharge.
•
additional electronic module for master/slave
operation (optional);
•
additional electronic module for monitoring, recording
and remote management (optional);
•
remote management system (optional).
The quality of the components used, the care of the
assembling process and the severe tests guarantee a
product of great reliability and safety.
Blocksystem sets are available for the following
temperature applications:
•
High temperature
•
Medium temperature MBP
•
Low temperature
They consist of the following different ranges:
6
HBP
+2°C/+10°C
-5°C/+5°C
LBP
-25°C/-15°C
In these machines the condensing unit, which is to be
installed on the external side of the cold room walls, is
separated from the evaporator, to be installed internally.
This enables the two items to be installed a certain
distance from each other. This solution grants an easy
and fast installation both on the floor and on the roof.
This range is available in two different versions: nitrogen-
charged with shut-off valve connections for all models
or, where available, pre charge refrigerant and fast
connections (ST/R). In this case it is possible to request
the supply of pre-charged connection pipes (for additional
details see the optional table related to each model).
Ceiling mounted evaporator. Thermostatic valve or
capillary expansion. Heater or ventilation defrosting.
ST models are equipped with remote control panel (10m
long cable).
SU
SU system consist of the condensing part of ST items.
The condensing units with housing will be supplied with
valve connections, nitrogen charge and thermsostatic
valve expansion. The standard version is supplied with
all components wired to a terminall box. Optional,
SU/12, built-in electrical box.
English
English
ST
Publicidad
