Descargar Imprimir esta página

Slime 40050 Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Inflator does not turn on:
1. Check the fuse, it may have blown: 12V fuse is
located in the plug adapter. Unscrew the tip,
remove fuse, and inspect. If necessary, replace fuse
with a 15A 250V (5mm×20mm).
2. Check vehicle's power outlet fuse; it should be a minimum of 15 amps.
3. Check receptacle and plug terminals for dirt (particularly tobacco). Use a non-conductive
probe (not fingers or metal) to dislodge and remove debris.
4. Push the power plug firmly into the receptacle and twist it back and forth.
Inflator runs but does not inflate:
1. Be sure the valve connector is tightly screwed onto the valve stem.
2. Check tire for leaks. Check hose for breaks and leaks at fittings.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for
25 minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim
allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary
to jack up the tire prior to inflation.
Warranty: For the period of one year from date of purchase, manufacturer guarantees that this Product will meet the
specifications when used as directed. Manufacturer's sole liability and Customer's sole remedy under any warranty
claim is limited to a Manufacturer's coupon for a replacement product upon return of unit and proof of purchase.
QUESTIONS OR COMMENTS: Call +1-805-489-0490 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.

Publicidad

loading