Fan Assembly. Pgs - Craftmade Cavalier CAV52 Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
downrod provided, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball and remove the pin and clip. Lower
hanging ball and remove stop pin. Slide hanging
ball off the original downrod, A, and slide it down
the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin
into top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the inside
of the hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
canopy, rod support cap, rod support (loosen rod
support set screw to prevent scratching the
downrod finish) and then the yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the
downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nut securely.
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
["Fan Assembly" continued on next page.]
set screw
A
electrical wiring
canopy
rod support cap
rod support
clip
page 5
set screw hole
stop pin
hanging ball
clip
B
downrod
rod support
set screw
yoke cover
yoke set screw
housing
pin
motor