Cequent Performance Products 24938 Instrucciones De Instalación página 4

Fascia removal – use 7 mm socket and T-15 stardriver to remove (10) bolts and (4)
screws, 1 bolt each side is hidden behind the wheel well liner. see Figure 2.
Bumper beam removal – Use 15 mm socket to remove (8) flange nuts, attaching
bumper to end panel, and then slide exhaust bracket off of the 2 lower studs then
remove bumper beam, see Figure 3.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Fascia removal – Gently remove the fascia and unplug wiring. Set bumper fascia aside.
Hitch installation – raise the hitch and align the attachment holes on hitch with studs on
the end panel. Raise the bumper beam and sandwich the hitch, re-align the exhaust
bracket with the 2 lower studs. see Figure 1. Reuse the flange nuts and loosely fasten
them.
Sheet 4 of 15 24938NP 2/14/16 Rev. A