Cequent Performance Products 24940 Instrucciones De Instalación página 7

5. Remove heat shield(s) – Remove the hex nuts (3 to 5 per heat shield)
holding heat shield(s) to bottom of vehicle. NOTE: Shield(s) will be
trimmed and replaced prior to installing hitch.
7. Install forward attachment fasteners – Using the 3/8 pull wires provided,
fish wire 3/8"-16 x 1" long carriage bolts and special washers (item 3) up
through 7/8" diameter holes and back down through same hole, both
sides.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Install rear attachment fasteners - Using 3/8 pull wires provided, fish
wire 3/8-16 x 1-1/4" long carriage bolts and special washers (item 3)
through 7/8" diameter holes in bottom of frame, both sides. Pull
carriage bolts down through 3/4" diameter holes toward rear of vehicle.
Forward Hole
7/8" Dia.
Rear
8. Trim muffler heat shield(s) - Trim heat shield(s), See figures 7, 8, and 9
for details on how to trim muffler heat shield(s).
9. Reinstall heat shields – Reinstall heat shields using same hardware
removed.
Sheet 7 of 24 24940N 3-14-16 Rev. A