Cequent Performance Products 76018 Instrucciones De Instalación página 4

1. Remove Lower Fascia - Use 8 mm socket to remove (8) screws and (4) plastic
expanding fasteners . Then gently unclip and pull fascia off and set aside for
reinstallation later.
3. Remove heat shield - Use 10mm socket to remove (4) nuts on the upper portion of
the heat shield.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Lower exhaust – Use 10mm socket to remove the nut on both rear exhaust hangers.
Then pry off 1 rubber exhaust hanger near the transaxle using exhaust removal pliers or
other suitable tool (spray with soapy water to make this easier).
4. Trim heat shield - Starting from the lower portion of the heat shield measure ½"
inward form the outermost screwholes, draw a line all the way across. On the upper
portion of the heat shield, draw a line all the way across the heat shield ½" from the top.
Trim across using the lines drawn (2 trim cuts) similar to Figure 2.
Figure 2
Sheet 4 of 18 76018NP 3-1-16 Rev. A