Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove bumper beam – using a 12mm socket, remove (8) M8
bolts, (4) per side, attaching bumper beam to end panel.
5. Hitch installation – raise hitch and bumper beam into position
aligning holes with weldnuts in the end panel. Sandwich the hitch
between bumper beam and end panel.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
4. Bumper beam modification – using an adjustable wrench, bend
the tabs on back of bumper beam up approximately 15 degrees.
6. Reinstall fasteners - Loosely reinstall the existing (8) M8 bolts into
weldnuts in end panel, (4) per side.
7. Tighten all fasteners with torque wrench to 20 Lb.-Ft. (27 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when
towing.
Sheet 5 of 18
24944NP
10-25-16
Rev. B
Publicidad
