Cequent Performance Products 24947 Instrucciones De Instalación página 6

5. Remove bumper beam - using an 15mm deep wall socket with 6"
extension, remove (6) flange hex nuts holding bumper beam to end
panel.
7. Hitch installation - raise hitch and bumper beam into position aligning holes with studs in the end panel. Sandwich the hitch between bumper beam
and end panel.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Trim underbody panel - using a tape measure, tape, & tin snips,
mark & trim the underbody panel as shown. See figure 2.
Note: The underbody panel may be trimmed in place or optional to
fully remove the panel for trimming.
5-1/2"
Sheet 6 of 21 24947NP
3-1/2"
3-3/4"
9-19-16 Rev. B