Maintenance And Inspection; Warranty Claims - Atlantic L-305 Manual De Producto

Maintenance and Inspection

• Regular maintenance and inspections are a necessity for continued efficient functioning.
If any abnormal conditions are noticed, refer to the section on Troubleshooting and take
corrective measures immediately.
Monthly Inspection
• Check for any drop in performance. Reduced performance is usually caused by debris
blocking the intake screen.
• Detach the power cable from the receptacle and turn off the power supply (circuit breaker).
• Disconnect the pump discharge and remove the pump from the water.
• Remove any accumulated debris from the surface of the pump, inlet screen and impeller.
• Make sure all nuts and bolts are fastened securely.
Winterizing
• Under no circumstances should the pump be left in frozen water.
• When the pump is out of use for an extended period, wash it and dry it thoroughly, then
store it indoors.
Note: Always run a test operation before putting the pump back into operation. When the
pump is left installed in water it should be run at regular intervals (about once per week).
Warranty
All TidalWave L-Series Pumps carry a two-year limited warranty. This limited warranty is extended
solely to the original purchaser commencing from the date of original purchase receipt and is
void if any of the following apply:
• The pump has been run while not fully submersed causing the thermal protection to trip.
Skimmers using inadequate vertical filtration may create "run dry" conditions.
• The pump was not run on a dedicated circuit.
• The cord has been cut or altered.
• The pump has be mounted horizontally.
• The pump has been run in salt or chlorinated water.
• The pump has been misused or abused.
• Serial number tag has been removed.
• The pump has been fully or partially disassembled other than described in this manual.

Warranty Claims

• In case of warranty claims, pump should be returned to place of purchase accompanied by
original receipt.
4