Mestra 080118 Manual De Instrucciones página 5

Drying oven
Warnings
Preventive measures
 Attention: before using the machine, please
completely read this operating manual.
 Keep this operating manual properly for fu-
ture.
 Do not allow children or non-qualified per-
sonnel handling the unit.
 Do not touch the unit or the power cord with
wet hands.
 Unplug the unit in case of storm and when
you are not going to use it for a long time.
 Place the unit in a dry place, away from dust
and water splashes.
 Do not pull, twist or fold the power cord
excessively.
 Do not wet the unit; do not use chemical
products to clean it.
 WARNING: to prevent electric shock haz-
ards, connect the unit to a proper power
source (grounded 230 V, 50/60 Hz).
 The machine features a precision circuit.
Prevent fortuitous impacts and stresses that
could cause mechanical damage.
 Do not mix potentially explosive substances.
 Remove any dirt or water from the cable
connection.
 Unplug the appliance immediately if you
detect noise, odor or smoke.
 Install the product away from heat sources.
 Do not use the appliance in particularly hu-
mid places, or near flammable materials (al-
cohol, solvents, etc.).
 Do not use the machine with products differ-
ent than defined in the intended use.
 To prevent accidents, be cautious when using
the unit.
 Always keep the device in idle mode, except
when mixing.
 Choose a flat and firm surface to place the
unit, away from heat or vibration sources.
 Do not dismount, repair or modify the ma-
chine.
 If you find a defective component or a pro-
blem do not use the machine.
 Contact us for questions or detailed trouble-
shooting information.
Intended use
The drying oven (ref. 080118) is designed to extract
moisture and keep the thermoforming gaskets dry avoid-
ing the formation of pores, for drying instruments, plas-
ter models, etc. in dental laboratories and clinics.
A fan circulates the hot air producing a uniform drying.
For optimum output and performance, we advise you to
read the following instructions with great care.
Installation
 Unpack the appliance carefully. You will find the
following items:
- Main unit.
- 1 plastic tray.
- 1 plastic grid.
- 6 stainless steel shelves.
 Make sure the drying oven sits firmly on a solid,
level surface.
 Place a plastic tray on the bottom of the oven interior.
 Place the plastic grid inside the tray.
 Place the 6 metal shelves on their supports.
 Connect the power cord to a grounded 230 V,
50/60 Hz electrical source.
Operation
1. Place the sheets or objects on the trays. Do not over-
load the trays:
Max. load = 600 g per shelf.
2. Close the door.
3. Press the TEMP/TIME button to toggle between
temperature and time.
4. Using the + / - buttons, select the desired tempera-
ture and operating time.
5. The default setting is 10 hours and 70 ºC.
6. Press the ON/OFF button to start the cycle or to stop
it.
7. The control will deduct the time until "0:00".
Heating will stop and the fan will continue to run for
10 seconds until an audible warning sounds.
8. Unplug the appliance when not in use.
EN

5