Remove A Window Covering From A Group; Additional Programming; Reset Window Covering Programming; Reset Travel Limits - Springs Window Fashions Levolor Manual De Instrucciones

Activating and Operating

REMOVE A WINDOW COVERING FROM A GROUP

1. Press and hold STOP until the WHITE programming
light starts flashing, then release. This puts the remote
in program mode.
2. Press the desired GROUP number (1, 2, 3, 4, 5 or 6)
on the remote. The BLUE GROUP indicator light above
the GROUP number will flash to show it is selected.
3. With one hand press and continue to hold the
manual control button located on the window
covering headrail.
4. While continuing to hold down the manual control
button, press and hold
until the window covering moves slightly to indicate
it has been removed from the GROUP.
5. Release both buttons.
6. To exit program mode press and hold
the lights stop flashing.
CREATING A DUPLICATE REMOTE
1. Remove the back cover from the new remote..
2. Using a paper clip, press and hold the recessed reset
button until the BLUE GROUP indicator lights double
flash followed by a triple flash, making a total of five
flashes. Note there will be a delay between the double
flash and the triple flash. Replace the back cover.
3. Press and hold STOP on the original remote until
the WHITE programming light starts flashing, then
release. This puts the remote in program mode.
4. With one hand press and hold ALL on the new remote.
5. While continuing to hold down the ALL button press
and release STOP on the original remote.
6. All of the BLUE GROUP indicator lights on the duplicate
remote will flash twice to indicate all of the information
from the original remote has been copied.
7. To exit program mode press and hold
llights stop flashing.
NOTE: This duplicate remote will now operate the same set
of window coverings and GROUPS as the original remote
10
Remote Control Guide
CLOSE on the remote
STOP until
STOP until the

Additional Programming

RESET WINDOW COVERING PROGRAMMING

This reset erases all programming stored in the window
covering, including GROUP assignments, preventing any
remote from operating the window covering. Reset window
covering program is used during installation to correct
GROUP assignments.
NOTE: This reset does not affect travel limits.
1. Press and hold the manual control button, located
on the window covering headrail. Continue to hold
the manual control button until the window covering
moves slightly up and down TWO times. This indicates
the window covering programming has been reset.
2. Release the manual control button.
3. Refer to "Join a window covering to a GROUP" on
page 8, to program the window covering to a group.

RESET TRAVEL LIMITS

1. Press and hold the manual control button, located
on the window covering headrail, until the window
covering moves slightly up and down ONE time.
This indicates that the limits have been reset.
2. Release the manual control button.
3. The window covering will now move on its own
to set both the top and bottom motor limits.
Once this process is done, the window covering
will move briefly in both directions.
If steps 1-3 do not resolve the issue, please follow the additional
steps below.
TO RESET THE BOTTOM LIMIT
1. Press the open button on the remote to run the
shade to the current top limit.
2. With one hand, press and hold the manual control
button on the window covering headrail. Use
your other hand to press the close button on
the remote.
3. Shade jogs and motor LED turns red to indicate
shade is in limit adjust mode. This mode will time
out and revert to old limits after ~30s of no action.
11
Remote Control Guide