Technical Specifications - Philips Avent SCF875 Manual Del Usuario

ENGLISH
26
Problem Possible cause
There are white There is limescale
spots on the water buildup on these
tank, water tank parts.
lid, jar, jar lid and
sieve.
The surfaces that Food colorings may
come into contact discolor the parts that
with food are come into contact
discolored. with food.
The appliance The jar is out of
sounds 5 times position or removed
and the steaming from the main unit
light flashes during during processing.
steaming, reheating
or defrosting.
Water in the water
tank is not enough
for the selected
processing time.
There is too much
limescale buildup in
the water tank.
There are food Small food residue
residues in the particles get into the
inner layer at the inner layer at the
bottom of the jar. bottom of the jar
during cleaning.

Technical specifications

- Voltage/wattage: See type plate on the bottom of the appliance
- Maximum water capacity of the water tank: 250 ml
- Maximum capacity of the jar: 1050 ml
- Operating temperature: 10°C to 40°C
- Protection: Temperature-controlled heating system
Solution
This is normal. Remove the limescale
periodically. Clean the water tank lid,
jar, jar lid and sieve with a moist cloth.
Descale the water tank. Refer to the
section "Descaling" in the chapter
"Cleaning and descaling".
This is normal. All parts are still safe to
use and will do no harm to the cooked
food.
Turn the control knob to the off position
(OFF), check the water amount in the
water tank, place the jar on the main unit
correctly, and reselect the processing
time to start again.
Turn the control knob to the off position
(OFF), and add enough water for the
selected processing time.
Descale the water tank. Refer to the
section "Descaling" in the chapter
"Cleaning and descaling".
Remove the jar from the main unit. Remove
the jar lid and blade unit from the jar.
Flip the jar, align the small hole on the
bottom to a tap and flush water into the
small hole. Use warm water to achieve a
better cleaning result.
Hold the jar handle and shake the jar for
about 15 seconds to mix the water with
the accumulated residues.
Pour out the water from the small hole.
Repeat above steps for several times
until the residues are cleaned.