Starting And Stopping Treatment; Starting Your Treatment - ResMed HUMIDAIRE 3i Manual Del Usuario

2 Remove the water chamber (E-3) and carefully fill it with fresh, clean water (E-4). Make
sure you keep the level of the water under the maximum water level mark (E-4a).
Always ensure that the water chamber is clean. See "Cleaning and Maintenance" on
page 10.
WARNING
!
Do not overfill the water chamber, as water may enter your flow generator and air
tubing.
CAUTION
!
Do not use any additives (eg scented oils and perfumes). They may reduce the
humidification output of the HumidAire 3i and/or cause deterioration of the water
chamber materials.
3
Carefully place the filled water chamber into the humidifier docking station (E-5) and
latch the cover (E-6).
The H A
UMID IRE
S
TARTING AND
S T
TARTING YOUR
Please refer to the illustration in section F of the illustration sheet.
1
When your H
UMID
indicator light lights up on the H
(not available on all models) may appear.
When activated, this feature allows the water to warm up before you start treatment.
2
If the Warm-Up feature is available, use it to pre-heat the water before starting your
treatment. Skip this step if you wish to start treatment immediately.
W -U F
ARM P EATURE
Note: Check your flow generator user's manual to see if this feature is available.
To start the Warm-Up feature:
i. Select Warmup by pressing the Right key on the control panel.
The following message is displayed for 2 seconds:
ii. After 2 seconds the WARMING screen is displayed.
3i is now ready for use.
S
TOPPING
REATMENT
A 3i is attached and the flow generator is powered, the
IRE
UMID
RAMP: 10min
menu
(
NOT AVAILABLE IN ALL MODELS
WARMING
menu
T
REATMENT
A 3i. A prompt for the Warm-Up feature
IRE
warmup
)
HUMIDIFIER
WARMING
exit
S
TARTING AND
S T
TOPPING REATMENT
7