EXTRAS: MISC SETTINGS
MULTI-TIMER
This feature enables different timed OPEN/CLOSE cycles for each day
of the week. To enable this feature, select it and then, using the UP/
DOWN buttons, select the correct day, i.e. If it is Monday today, select
MON and then press MENU to confirm.
Now, when you go into the OPEN/CLOSE settings and select TIMER
you will need to set the day and time of the cycle. If for example you
wanted a different time for Saturday, navigate the >> << symbols
to the day, press MENU and then using the UP/DOWN button,
change the day to SAT and then press MENU. Now the hour will start
flashing. Adjust it to the new time and press MENU. Do the same for
the minutes. If you want to change other days, simply repeat. When
finished, navigate to EXIT and press MENU to save everything. To
disable this feature, simply navigate to the MULTI -TIMER menu and
select NO.
CLOCK 12/24HR
You may change the time format here by simply selecting your
preference using the UP or DOWN buttons.
SENSOR DELAY
This feature allows you to set a delay when using the Light Sensor.
For example, if the door was closing a little bit too early when using
the Light Sensor, you could enable this feature and then, when you
select SENSOR in the CLOSE Settings, you now have the option of
delaying the closing by anything from 0 to 60 minutes. Simply press
the UP/DOWN button to increase/decrease the delay in 5 minute
intervals. It is also possible to adjust the Light Sensor sensitivity in the
LUX Adjustment Menu. To disable this feature, simply select NO in the
SENSOR DELAY menu.
EXTERNAL POWER
When using an external power source, select this option to disable the
battery check, otherwise when using 5 volt power supplies, you will
get a Battery Warning indication.
UNLOCK SENSOR
Only needed if you want to upgrade a Standard model to enable the
use of the Light Sensor. Just let your vendor know the code number
displayed and they will supply you with the unlock PIN. There is an
upgrade fee for this service.
FIRMWARE AND BATTERY CHECK
Displays the firmware version and the status of the battery.
6
chickenguard.com