KSIX COLORLED Manual De Usuario

COLORLED
User manual
BXLEDST10M
Technical information
LED: 5050RGB
LED Quantity: 30 pcs per meter
Output power: 24W
Input voltage: AC 100V-240V
Output voltage: DC12V
Distance of remote operation: within 5m
Working temperature:-20-+45°C
Illumination angle: 120°
Dimensions: 10000*10* (mm) *1
Lumens: 12-15 lm per LED
Illustration
Attention: make sure the arrows connect
properly or the light won't work.
REMOTE CONTROL INSTRUCTIONS
① Increase / Decrease brightness
② 16 static colors
③ On / O
④ Flash e ect
⑤ Stroboscopic e ect
⑥ Fade e ect
⑦ Smooth e ect
FAQS
The LED strip does not light up after connecting the controller and power on.
1. Check the power input: Please use our supplied adapter or any other power source which
is of the same type as our adapter. LED light must be used under 12V voltage.
2. Check if the controller and the strip are properly connected. Confirm all connections are
OK.
3. Check if the remote control is switched on.
The LED strip is on, but the remote controller is not working or cannot control the LED
light.
1. Check if the insulation plate is in the remote control.
2. Check if the battery of the remote control is well placed.
3. Confirm that you are within 5m and align with infrared sensor.
4. Try to change the battery.
In the box
2 led strip
1 remote control
1 AC adapter
1 User manual
1 Infrared receiver
2 grippers
OFF
1
R G B
2
DC12V Power input
Infrared sensor
ON
3
W
4
FLASH
5
STROBE
6
FADE
7
SMOOTH