Kohler K-704310 Guia De Instalacion página 9

Tape
Level
5. Install the Wall Jambs
Make sure the wall jambs are level
With a pencil, mark the three drill hole locations in each wall jamb on the wall.
NOTE: On ceramic tile, use a center punch to nick the surface glaze at the mark. Tap the punch lightly
with your hammer so you do not crack the tile.
Remove the wall jambs, lightly center punch the hole locations, and drill the six screw holes using a
5/16" (8 mm) drill bit. Use a masonry bit for ceramic tile.
After drilling, thoroughly clean the bath or shower ledge. Insert wall anchors into each of the six
drilled holes.
Position the wall jambs by aligning the wall jamb holes with the drilled holes.
Loosely secure each wall jamb to the wall at the top and center hole locations using #8-18 x 1-1/2"
panhead screws.
Kohler Co.
Mark holes.
Drill holes.
Wall Jamb
9
#8-18 x 1-1/2"
Panhead Screw
Wall Anchor
1015440-2-C