Main Screen - TECO TECOnnect Manual Del Usuario

5.3.1 ADDITION
To add another TECOnnect, press the icon on the bottom left
Setup screen.
Go to paragraph 5.2.
5.3.2 RECONFIGURATION
If the module must be reconfi gured, e.g. replacing the router or modifying the
WI-FI, proceed as follows:
Disconnect TECOnnect from the power supply.
Reset the TECOnnect module using a clip or similar in the point indicated on the
technical data label. Keep pressed and also connect the power supply cable,
keeping the TECOnnect LEDs visible. Wait a while, until the red and green
LEDs fl ash together; the device will be reset.
Proceed to confi gure in point 5.3.
5.4 OPERATION
5.4.1

MAIN SCREEN

Once setup is complete, you can access the main screen of the application.
The big, central number followed by the degrees (°C or °F) is the temperature
of the water.
The small number beneath is the temperature value required.
There may be an icon beside the set point:
The appliance is cooling.
The appliance is heating.
If the appliance is not cooling or heating, no icon will appear.
The white line under the set point shows the temperature trend over time and,
clicking on it, the detailed graph screen appears.
The SET key and the arrows are used to set the temperature.
The RANGE displayed on the bottom left is the interval set by the user using the
settings screen. IF OFF, there is no interval set.
If there is no alarm, the white icon
If there is an alarm displayed, the intermittent red image
gside which indicates the alarm type. See paragraph 7.
The SIGNAL icon
On the top right, the name of the appliance is indicated whose settings are
indicates the connection status. See paragraph 7.
EN-18
is displayed.
to enter the
has a code alon-