TECO TECOnnect Manual Del Usuario página 21

being displayed.
The bottom icons are:
SETUP
SETTINGS
USER ACCOUNT
CONTACTS
LINK
5.4.1.1 MODIFY THE SET POINT
To modify the set point, press the SET key and then press the arrows and lastly
press SET again to confi rm the choice made. Wait a few seconds to activate
the thermostat change.
5.4.2 MAIN LANDSCAPE SCREEN
An image is displayed similar to that of the thermostat on the controlled ap-
pliance.
If you press SET, the set point is displayed. To edit it, press the arrows and
lastly the SET key.
On this screen, you can also switch off the refrigerator with the key POWER
The writing OFF is displayed instead of the water temperature. Wait approx. 20
seconds to activate the thermostat change.
To switch on the appliance, press again the POWER
5.4.3 SETUP
To setup and reconfi gure TECOnnect, see paragraph 5.3.
5.4.4 SETTINGS
The settings display and enable editing of the parameters displayed on the ther-
mostat of the appliance. Use + and – to set the desired values and press "Save
setting".
AL temperature range can be enabled or disabled using ON/OFF. You can set
the value of the range between + and – and confi rm it by pressing the "Save
setting" key.
The range must be a unit higher than the hysteresis.
If the temperature will reach the value of the set point is plus or minus the range,
a message will be sent on the smartphone and the warning will be displayed on
the main screen.
EN-19
.
.