Publicidad
Idiomas disponibles
Idiomas disponibles
READ ALL INSTRUCTIONS – WARNING:
When portable fixtures are used outdoors basic safety precautions should always be followed
to reduce the risk of fire, electric shock and personal injury, including the following:
A. Use only three wire outdoor extension cords that have three prong grounding plugs and
ground receptacles that accept the appliance's plug.
B. Ground fault circuit interrupter (GFCI) protection should be provided on the circuit(s) or
outlet(s) to be used for the wet location portable fixture.
C. Use only with extension cord rated for outdoor use, such as an extension cord type SW,
SOW, STW, STOW, SJW, SJOW,SJTW, SJTOW, SJEOW, SEOW
SAFETY INSTRUCTIONS FOR LED WORKLIGHTS
• Do not open the work light body; no user serviceable parts inside.
• Never operate the fixture with missing glass or acrylic safety shield.
• This fixture is not intended for use or safe to use in potentially dangerous locations such as
places with explosive or flammable atmospheres.
• Do not handle this fixture when standing on wet or damp surfaces or in water. To reduce the
risk of electrical shock, this light should always be plugged into a properly grounded 3 wire
outlet. Do not remove the ground wire or grounded plug from the fixture. Always use a UL
listed 3 wire grounded cord with electrical capacity to properly handle this light and other
tools you might be using. Never use light around swimming pool, hot tubs or saunas.
• Always wear safety glasses when working in close proximity of the floodlight while ener-
gized.
• This unit has a polarized plug. One blade is wider than the other. As a safely feature this plug
will fit in the polarized outlet only one way. If plug does not fit in outlet, reverse direction. If
it still does not fit, contact a qualified electrician. Never use with an extension cord unless the
plug can be fully inserted. Do not attempt to defeat this safety feature.
• Keep fixture 18 inches from combustible materials such as cloth, wood or paper. Lighted
fixture gets hot! This fixture should not be used inside dwelling.
• Do not look directly at lighted bulb. Do not remain in bright light if skin feels warm as you are
too close to the fixture.
• Keep fixture away from children.
• Never use around heavy volatile fluids such as gasoline.
WORKLIGHT SLED BASE ASSEMBLY INSTRUCTIONS
Tighten wing nuts on sides of worklight head so yoke is in upright position. Position center
hole in yoke over hole in crossbar of sled base. From underside of crossbar slide black bolts
through hole in yokes. Tighten black nuts to secure yoke to sled base.
Crossbar
Bolts
Publicidad
