Cequent Towing Products 36297 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: Uses Existing Fasteners
Wrenches: 17mm
Drill Bits: None
Heat Shield
Exhaust Hanger Bracket
Existing fasteners
typical both sides
1. Remove tie-down bracket from passenger side frame rail.
2. Remove two (2) exhaust hanger bracket bolts from driver side frame rail.
3. Lower exhaust hanger bracket and heat shield.
4. Raise hitch into position and install between frame and exhaust hanger bracket using existing fasteners as shown above.
5. Return tie-down bracket to vehicle owner.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2000, 2001, 2003, 2006, 2015 Cequent Towing Products – Printed in Mexico
Installation Instructions
Bumper
(Sold separately)
Drawbar Kit:
36061
Drawbar must be used in the
Rise position only.
Existing Weld Nuts
Tighten all M12 CL9.8 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Volvo V70
Volvo S60
Do Not Exceed Lower of Towing Vehicle
3500 LB, (1589 Kg) Max Gross Trailer Weight
Wiring Access Location: PC3, PC4
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
300 LB, (136 Kg) Max Tongue Weight
Frame Rail
N36297 10-22-15
Form: F205 Rev A 5-6-05
36297
06420
Rev. C