Publicidad
Idiomas disponibles
Idiomas disponibles
Remove this bolt
short-bed. Leave
shield in place
between frame and
hitch bracket.
7
6
Conical toothed washers
*4
*3
Use these fasteners when
installing bolt-on brackets
only. Conical toothed
washers and nuts used
other side. (not shown)
Tighten 1/2"-13 Gr.5 bolts with torque wrench to 75 Lb.-Ft. (102 N*M) Tighten M14 x 2.0 CL10.9 bolts to 115 Lb.-Ft. (156 N*M). Tighten ½"
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water
and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection.
Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2014 Cequent Performance Products – Printed in México
Installation Instructions
GMC Sierra/Chevrolet Silverado 2500 & 3500 HD Pickups.
Looking up underneath passenger side frame rail,
showing plastic spare tire shield
Magnified view from previous page showing detail
of bolt-on brackets for short-bed trucks ONLY.
This slot not used on
short-bed trucks.
*4 *5
and nuts on back side
(not shown)
bolts with handle nuts to 50 Lb.-Ft. (68 N*M)
Bolt-on bracket,
use on short-bed
only. Typical both
sides
Sheet 2 of 6
Part Numbers:
Trim plastic if needed in area
shown on short bed trucks
Picture 1.
Plastic spare tire shield
*8
between bottom of
thru frame, block
75906N
5-23-14
Form: F205 Rev A 5-6-05
75906
87664
44749
Figure 2.
Insert block
frame and top of
bolt-on bracket.
Drop bolt down
and bracket.
Rev. A
Publicidad
