Yakima RocketBox 15s Manual Del Usuario página 4

CLOSE THE BOX:
Pull the lid down.
a REPLACEMENT LOCK FOR SAME-KEY-SYSTEM® USERS:
Yakima SKS® locks purchased separately. (If you wish to install matched-key locks; keep this instruction for replacement lock installation).
• Insert lock key and rotate the lock to
align lock depression with point on rim.
• REMOVE lock key.
• Insert control key (from kit purchased
separately).
CHECK INSTALLATION BEFORE DRIVING AWAY
Make sure
installation is secure
by tugging at box.
1033524A-4/15
LOCK THE BOX FOR A
SECURE CLOSURE!
• Overstuffi ng the box
• Check the closure by
180°
• To lock the box, turn
Remove key
with lock
attached.
TO OPEN THE BOX, unlock it. With the key still inserted, raise
the lid. The key cannot be removed while the box is open.
will prevent closure.
UNLOCK / OPEN
pushing up on the lid.
key all the way to the
right until horizontal.
Remove key.
Insert control key into the
new lock, and install.
Keep the depression
aligned to the point.
LOCK NOT LOCKED! *
* See 11a below.
• Push the core completely into the housing.
• Turn the key to a horizontal position.
• Hold the core with the tip of your thumb
and pull out control key. The lock should
remain in the housing.
• The box should not slide
on the bars.
• Open the box and tighten
red knobs if necessary.