Matco Tools SK8MAT Manual De Instrucciones

WARNING
Study, understand and follow all instructions provided
with this product. Read these instructions carefully
before installing, operating, servicing, or repairing this
tool. Keep these instructions in a safe, accessible place.
INTENDED USE OF THE TOOL
The SK8MAT is intended to be used for soldering, heat
shrink and general wiring and terminal repair. Do not
use this tool outside of the designed intent. Never
modify the tools for any other purpose or use.
BEFORE USE
Before use, READ AND UNDERSTAND THE WARNINGS
ON PAGE 5 and check the parts diagram and part
number listing on page 6 to make sure all parts are
included. If any parts are missing or damaged, please
call your distributor.
Caution: To help prevent personal injury
Normal use of this product is likely to expose the user to
dust and/or microscopic particles containing chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Always wear
appropriate safety equipment and clothing when using
this product. Study, understand and follow all instructions
provided with this product. Failure to read and follow all
warnings and operating instructions may result in
damages, serious injury or death.
• Always wear ANSI approved goggles when using this
product (users and bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool or use of the tool with
accessories not designed for it could result in serious
injury or death.
• Always select the correct accessories of the correct
size and design for the job that you are attempting to
perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
• Do not begin repairs without assurance that vehicle is
in secure position and will not move during repair.
DO NOT DISCARD – GIVE TO USER
8 PIECE SOLDERING KIT
Torches must be empty when returned for warranty.
The manufacturer warrants this product to the original user against
defective material or workmanship for a period of 1 year from the
date of purchase.
The manufacturer reserves the right to determine whether the part
or parts failed because of defective material, workmanship or other
causes. Failures caused by accident, alteration or misuse are not
covered by this warranty.
The manufacturer, at its discretion, will repair or replace product
covered under this warranty free of charge. Repairs or replacements
of products covered under this warranty are warrantied for the
remainder of the original warranty period.
The manufacturer or its authorized service representatives must
perform all warranty repairs. Any repair to the product by
unauthorized service representatives voids this warranty. The rights
under this warranty are limited to the original user and may not be
transferred to subsequent owners.
The warranty is in lieu of all other warranties, expressed or implied,
including warranties of merchantability and fitness for a particular
purpose. Some states do not allow the exclusion or limitations of
incidental or consequential damages, so the above limitations may
not apply to you.
Durable. Features a leak-free tank for extended storage
as well as triple plated tip, heavy duty ignition and
non-oxidizing internals for long lasting, repeated use.
Comprehensive. Includes LBSI torch and clear cover,
lead-free solder, heat shrink deflector, sponge w/tray,
and pointed, chisel, anvil, needle and angle knife
soldering tips.
Powerful. Replace up to a 150W soldering iron with
2,400°F flame, and 840°F to 1100°F tip temperature
for up to 75 minutes.
Page 1
1 YEAR LIMITED WARRANTY
(TORCH. ACCESSORIES ARE CONSUMABLE.)
PRODUCT INFORMATION
SK8MAT
Made in Taiwan
to Matco specifications
1702073-14 MA