Cequent Performance Products 75992 Instrucciones De Instalación página 4

2. Remove (1) screw at the fascia center support and carefully push it toward impact
1. Lower exhaust by removing (3) rubber isolators as shown in Figure 1. Use
exhaust support stand to prevent damaging muffler. bar as shown in Figure 2. Return (1) screw to owner.
3. Remove heat shield on both sides. Remove (3) screws, (1) plastic plug on both
4. Trim the tab off heat shield on both sides, as shown in Figure 3. Reinstall the heat
sides, and (1) plastic clip attaching wiring harness only on driver side.
shields without (2) screws which attach to the frame rails on each side. Return (4)
screws to owner
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 4 of 15 75992NP 03-26-15 Rev. B