Fcc/Ic Compliance Statement; Industry Canada Statement - Midea MRQ22D7AST Manual De Usuario

NOTES
•
When connecting the device to the network, make sure the mobile
phone is as close as possible to the product.
•
Use an English letter combination only for the router WiFi name.
•
To avoid the impact of signal instability on the network, the number of
connected devices under the same router should not exceed ten.
•
If the router or WiFi name or passwords change, delete the registered
appliance, and repeat the Download and Install process and reconnect.
•
As the product technology is updated, the content of "msmartlife" may
be changed. For the most current information refer to the "msmartlife"
presentation guide.

FCC/IC COMPLIANCE STATEMENT:

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However,there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/television technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications to this unit not expressly approved by the
manufacturer could void the user's authority to operate the equipment.

INDUSTRY CANADA STATEMENT

This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada's licence
exempt RSS(s). Operation is subject to the following two conditions:
1.
This device may not cause interference.
2.
This device must accept any interference, including interference that
may cause undesired operation of the device.
32