Kohler K-1114 Manual De Instrucciones página 2

21"
(53.3 cm)
3-3/4"
(9.5 cm)
11-1/16" (28.1 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
Product Information
Drop-in, integral flange,
heater, left drain
Drop-in, integral flange,
heater, right drain
Drop-in cut-out dimensions:
70-1/2" (179.1 cm) x 40-1/2" (102.9 cm)
Fixture*: basin area
Bathing well 55" (139.7 cm) x
23-1/4" (59.1
cm)
water depth
To overflow 15" (38.1 cm)
* Approximate measurements for comparison only.
Pump: Hp
1-speed 1.25
Heater kW
1.5
Minimum access panel pump/control:
20" (50.8 cm) W x 15" (38.1 cm) H
1047190-1-B
72" (182.9 cm)
3/8" (1 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
K-1112-LH shown
K-1112-RH not shown
top area weight
64" (162.6 cm) x 132 lbs
32" (81.3 cm) (60 kg)
capacity
78.5 gal (297 L)
V Hz A
120 60 7.5
V Hz A
120 60 12.5
required
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Recommended faucet area
1-1/4"
(3.2 cm)
Pump/Control Access
1-1/4" (3.2 cm)
21"
19-1/2"
(53.3 cm)
(49.5 cm)
1-1/2" OD
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Heater
Locate the outlets behind the whirlpool and within 24" (61 cm)
of the pump and heater.
Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 80
lbs./square foot (390 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1. All dimensions are
nominal.
2
1-1/2"
(3.8 cm)
Tile Flange Drop-In Rim
Detail Detail
42" (106.7 cm)
120 V, 15 A, 60 Hz
120 V, 15 A, 60 Hz
Kohler Co.