Initial Setup - Manhattan 178709 Manual Del Usuario

Initial Setup

Connecting
You can connect the headphones two ways to enjoy audio:
• Create a wireless connection to a mobile device or computer that features Bluetooth wireless
technology (see Bluetooth Pairing below); or
•
Use the included 3.5mm stereo cable to connect (H) to an audio source (which doesn't require
charging the battery first). Note: The buttons — Multifunction (A), Previous (B), Next (C), Play/Pause
(D) — and volume dial (F) work only during Bluetooth wireless operation.
Built-in battery charging
Prior to initial use as wireless headphones, the built-in battery needs to be charged. A full charge can
take up to 3 hours, but you can listen to music or make phone calls while charging.
1
Use the included USB-to-micro USB cable to
connect the headphones (E) to a powered
computer or other charging device.
2
The LED (G) lights red while charging and turns
off when the charge is complete. Note: The LED
flashes red to indicate low voltage. Recharge the battery as soon as you can. For details, see About
the Battery below.
Bluetooth Pairing & Wireless Operation
This product utilizes the latest in Bluetooth wireless technology; wireless performance may vary from
device to device. If using this product with a Mac or PC, ensure that your Bluetooth driver is up to
date. If it isn't, visit your computer manufacturer's website for details and updates.
1 Press the Multifunction button (A) for about 5 seconds, until the LED (G) alternately flashes red and
blue. Note: Pressing the Multifunction button for just 3 seconds will put the headphones in Standby
mode (the LED lights red, then flashes blue only).
2
With the LED (G) alternately flashing red and blue, activate your device's Bluetooth function and
search for Bluetooth devices. Refer as needed to the manual of your phone, tablet, computer, etc.
regarding the Bluetooth operation of your source device.
3
Once the device finds "manhattanFATHOM, " an on-screen prompt will ask if you're ready for pairing.
Click or press OK or Confirm to continue. Note: If the device prompts you to enter a PIN, enter 0000
and click or press Yes or Confirm to continue.
•
After a successful connection is made, the LED (G) will flash blue and the headset will beep. If the
pairing has failed and the LED is still alternately flashing red and blue, the pairing procedure needs
to be re-initiated on your source device.
Pairing with more than one device at a time (Multipairing)
These headphones can connect with two types of devices: those using a Hands-Free or Headset
Profile (HFP orHSP), such as smartphones; and those using an Advanced Audio Distribution or Audio/
Video Remote Control Profile (A2DP or AVRCP), such as laptops. To pair the headphones with a phone
and any other Bluetooth-enabled devices, pair with the other devices first, then turn them off before
pairing with the phone last. When the other devices are turned on again, they will connect with the
headphones automatically.
• Once multiple devices have been paired, the headphones will remember each one unless they are
deleted from a device's Bluetooth profile.
• If the headphones are paired with a phone that supports both types of profiles (HFP and A2DP, for
example), simultaneous connections may be made that won't allow other devices to be connected.
Reconnecting to a Bluetooth-enabled device
Every time the headphones are turned on, they'll automatically connect to the last connected device.
• If the headphones are in Standby mode but not connected to any HFP devices, briefly press the
Multifunction button (A) twice to connect to the last connected HFP device.
4
ENGLISH
LED Indications
Mode Description
Standby Flashes blue
Low battery Flashes red
Incoming call Flashes blue rapidly
Charging Lights red
Mode Description
Powering on Flashes blue
Powering off Flashes red
Pairing Alternately flashes
red and blue