Publicidad
Step 13
IMPORTANT: You will need someone's help in this step.
å
Fasten the TOP (D) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT TABLE
å
MECHANISMS (23M) and into the holes in the ENDS.
NOTE: Be careful when lining up the holes in the MECHANISMS with the holes in the ENDS as to not damage any parts.
å
Fasten the BUSHINGS (91M) to the ENDS (A and B). Use two BLACK 3/4" PAN HEAD SCREWS (85S) through the
å
BUSHINGS, through the LIFT TABLE MECHANISMS, and into the ENDS.
NOTE: Do not overtighten the SCREWS (85S).
å
Do not overtighten
the SCREWS (85S).
85S
BLACK 3/4" PAN HEAD SCREW
(2 used for the BUSHINGS)
91M
NOTE: Be sure to use
the exact holes shown
for the SCREWS.
1S
www.sauder.com/services
D
23M
85S
A
414856
These four holes
must be here.
23M
91M
B
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
1S
Page 17
Publicidad
