jbc DDVE-1B Manual Del Usuario página 11

DR560 Glass Solder Collector Cleaning
1. Removing the lid
The lid must be unscrewed with the DR560 in a
vertical position.
3. Inserting the glass solder collector
The glass solder collector must be inserted
with coil filter in place, positioned between the
2 lines marked.
Then the whole unit must be closed by
screwing the lid.
2. Cleaning
Check
internal joint
Remove the coil and clean the inside of the glass
solder collector with the cleaning stick.
Check filter
Lid
Check the filter and replace it if it is dirty or
damaged.
w w w.jbctools.com
Marks
11