Cleaning Air Filter - Faber e-MatriX Manual Del Propietário

Maintenance
4.
Disconnect the 2 connectors, located on the right
side of the water sump.
5
. Release the 2 clips on both sides and remove
the nozzle.
6
. Gently lift up the water sump without spilling
any water.
20
7.
Remove the transducers and empty the water
sump.
8.
Clean and rinse the sump and transducers:
• Put a small amount of liquid detergent into the
sump.
• Use a soft brush to clean the sump.
• Clean the transducers, including the discs
underneath the cone. Remove the cone by
turning it clockwise.
• Thoroughly rinse the water sump with clean
water to remove all traces of detergent.
9.
Clean the nozzle with a soft brush and flush out
thoroughly with water.
10.
Reverse the steps to reassemble.

Cleaning Air Filter

1
. Gently slide the air filter upwards out of its
plastic holder
2
. Gently rinse with water in the sink and dry with
fabric towel before returning.
3.
Replace the filter making sure that the coarse
black filter is facing the front of the fire.
4.
Place the fuel bed and the front glass (see the
instructions in the section "Preparing the Fireplace
for Placement" on page 8).
www.faberfire.com