Cooper Metalux Instrucciones De Instalación página 3

Center Pendant Mounting-
Install and tighten a length of ¾" ridged threaded conduit to
the center hub located on the top of the housing (Figure 5).
For IP-65, apply pipe sealant prior to attaching the conduit.
Install and tighten the 10-24 lock screw to lock the conduit in
place.
Lock Screw
Figure 5.
Cable entry can be achieved by running the cable through the
conduit directly into the housing. Be sure that the opposite
end of the conduit is IP-65 if desired. Cable entry can also be
accomplished through either of the ½" NPT ports located on
the housing top.
Driver access and wire connections are the same as above.
Installation Instructions – Benchmark High Bay
3/4" Rigid Conduit
(2) 1/2" Hub
COOPER LIGHTING SOLUTIONS
Non-IP-65 Installation
N This type of installation does not meet IP65
ote:
requirements and will void the fixture IP65 rating.
Hook Mounting-
Install and tighten the damp location fixture hook into the
center hub located on the top of the housing. Install and
tighten the 10-24 lock screw to lock the hook in place.
Cable entry can be achieved by running SO cable through the
center hole of the fixture hook (Figure 6) or through either of
the ½" NPT ports on the housing top using the appropriate
fittings.
Driver access and wire connections are the same as above.
Cable Feed Thru
Hole
Figure 6.
IB507010EN Installation instructions
3