Craftmade C201 Guia De Instalacion página 9

9. Light Kit Assembly, 1-light Options. (cont.)
(Only for models C209 and E209)
Remove 3 screws from switch housing cap (at
top of light kit fitter). Make sure pull chain is
threaded through corresponding hole in light
kit fitter.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Be sure that molex
connections snap together completely.
Align holes in switch housing cap with holes in
switch housing. ( Note: The gap on the edge of
the switch housing cap must align with the
reverse switch on the switch housing for the
proper fit.) Attach light kit fitter with screws that
were previously removed. Securely tighten all 3
screws with Phillips screwdriver.
Thread fan pull chain through corresponding
hole in light kit fitter.
Install bulbs included with light kit.
Important: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
Locate slots on glass shade and align with
protrusions on light kit fitter. Push up gently on
glass shade and turn to the RIGHT (clockwise)
until glass shade locks into place. Pull down
gently on glass shade to make sure that it is
secure.
Please proceed to Section 11 on page 10 to
complete installation.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
molex
connections
bulb
page 8
motor housing
switch housing
switch housing cap
light kit fitter
light kit fitter
protrusion
slot
glass shade