LEGRAND Wattstopper FS-555 Instrucciones De Instalación página 2

The FS-555C is designed for use in hanging light fixtures where the cones face downward over the coverage area. This gives the
FS-555C a large rectangular shaped coverage pattern.
1. Review Figures 4, 5, and 9 to determine appropriate load wiring to the FS-555 and Occupancy Mode Switch setting for the sensor.
2. Determine an appropriate mounting location inside the light fixture.
3. See template (Figure 3b) for dimensions to determine cut-out and mounting hole locations in the fixture.
4. Install the sensor to the inside of the fixture using the included screws.
5. Restore power from the circuit breaker.
Key Product Dimensions
2- R 0.10
Figure 3a.
The Occupancy Mode Switch should be set to OFF for these wiring configurations.
Wiring Directly to Load
120/277 VAC
Line
Neutral
Ground
Figure 4.
FS-555C Mounted parallel to floor in ceiling fixture
Figure 2b.
WARNING: TURN THE POWER OFF AT THE
CIRCUIT BREAKER BEFORE WIRING.
6.11
5.72
5.56
5.19
2- R 0.10
5.68
WIRING A SINGLE SENSOR
Lighting Load
NO
NC
Common
INSTALLATION
2- Ø 1.10"
FS-555C
(with the cones)
Ø 0.71"
4- Ø 0.20
FS-555
(without the cones)
Figure 3b.
120/277 VAC
Figure 5.
2
Cut-outs in Fixture
4.0"
2.0"
Ø 0.24"
0.79"
0.37" 0.37"
0.22"
Ø 0.33"
"
0.39
Ø 0.19"
Wiring 0-10 VDC Dimming Ballast
Output to Lamps
0-10 VDC
Dimming Ballast
Line
Neutral
Ground
2- Ø 0.16"
0-10 Volt Control Wiring
Grey
NO
(-) ommon
NC
Common
Violet
(+)