Making The Electrical Connections; Mounting The Light Fixture - Defiant DFI-5982-WH Guía De Uso Y Cuidado

Installation (continued)
4
Installing the 1-2- asy
Connect™
□
Connect the ground wire on the mounting
bracket (FF) to the house ground wire using a
wire connector (EE).
□
Route the junction box wires through a hole in
the 1-2- asy Connect™ (D).
□
Place the 1-2- asy Connect™ (D) against the
junction box.
□
When mounting to a wall, the "UP" arrow
must point upward.
□
When mounting to an eave, the "UP" arrow
must point toward the building.
□
Insert the mounting bolt (DD) through the
1-2- asy Connect™ (D) center hole and thread
it into the center hole of the mounting bracket
(FF). Tighten the bolt (DD) securely.
□
Firmly pull on the 1-2- asy Connect™ to verify
it is securely attached to the mounting bracket.
DD
6

Mounting the light fixture

NOTICE: The two pins on the rear of the light fixture must be
inserted into the terminal block for the light to work.
□
Align the bottom edge of the light fixture (B) with
the bottom edge of the 1-2- asy Connect™
(D). Tilt the light fixture (B) toward the 1-2- asy
Connect™ (D), making sure the light fixture (B) is
centered on the 1-2- asy Connect™ (D).
□
Tighten the two mounting screws (CC)
securely to the 1-2- asy Connect™ (D). Do not
overtighten.
5
EE
FF
D
6
Making the electrical
connections
□
Insert the junction box wires into the side of
the terminal block. Tighten terminal block
screws to secure the wires.
□
Insert the white wire from the junction box
into the terminal marked "N (White)".
□
Insert the black wire from the junction box
into the terminal marked "L (Black)".
Black
Noir
Negro
L
N
White
Blanc
Blanco
D
D
B
CC