Installation Instructions - PVI SFW230 Manual Del Usuario

INSTALLATION INSTRUCTIONS

1. Ramp comes preassembled. Position the
ramp approximately the ramp's length out
from the step or platform. Stand ramp up on
end with the open ends down and the handle
side toward you. Reach down and lift first half
of ramp toward the step or landing area and
set it down on top of support. Make sure hook
is pressed firmly against step.
2. Open top half of left side ramp panel (A).
3. Unfold left side ramp panel (A) toward you
and once again make sure ramp hooks are
pressed firmly against landing area.
1.
Place single-fold ramp (A)
approximately the ramp's length out
from the step or platform. Stand
folded ramp up with top ends up (ends
with holes). Carefully tilt ramp toward
the step or landing area and set it
down on top of support. Make sure
hook is pressed firmly against step.
Unfold top half of single-fold ramp (A)
toward you and once again make sure
ramp hooks are pressed firmly against
landing area.
2.
Position single-fold ramp (A) in desired
location. Locate both holes at end of
the single-fold ramp (A). Mark the pin
locations using a pencil.
3. Remove the single-fold ramp (A) and
then, using a drill and 5/16 bit, drill a
hole approximately 2 inches deep.
4
5
1
2
3
A
B
A
B
A
B