How To Use - Taurus Alpatec AC280KT Manual Del Usuario

INSTALLATION
- Be sure to remove any packing material from
the inside of the appliance.
- Respect the legal provisions regarding safety
distances with other elements such as pipes,
electric conductors, etc.
- Make sure the appliance is level with the floor
- Do not cover or obstruct any openings in the
appliance.
- The plug must be easily accessible in order to
disconnect it in case of emergency.
MOUNTING THE EXHAUST PIPE:
- Stretch the tube, and screw its end to the air
outlet connector.
- The length of the air outlet pipe conforms to
the technical characteristics of the appliance.
Do not use air outlet tubes of different sizes or
materials, as they may cause faults.

HOW TO USE

USE:
- Unwind the cable completely before plugging
in.
- Plug the appliance into the mains.
- Orient the appliance to direct the air flow to the
desired direction.
- Switch the appliance on by pressing the On /
Off button (a), (I)
- Select the desired mode
- Select desired speed
FAN SPEED:
- Under the cooling and the fan mode, the speed
goes as follow: Lower fan – Mid fan – High fan.
- Under the dehumidifying mode, the fan is wor-
king in low speed.
TIMER FUNCTION:
- The appliance´s operating time can be control-
led from 1~24h.
- Press that button. If you press the button once,
the appliance will be working for 1 hour, if you
press twice, 2 hours, etc., up to 24 hours.
- Auto-shut off timer is only available when the
unit is on.
- Under the cooling mode, the setting temperatu-
re ranges from 16º~31ºC.
COLD MODE:
- Press mode to select cold mode, the cold
mode indicator will light up.
- Press + or - to set the temperature in a range of
16 ~ 31 °C.
- Pressing + or - once, the temperature will
increase or decrease gradually.
FAN MODE:
- Press mode to select the fan mode and the fan
indicator will light up.
- Press speed to select high speed or low speed.
- Temperature and sleeping function cannot be
setup.
DEHUMIDIFIER MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Under dehumidifying mode, sleeping function
cannot be setup, and fan speed is low.
SLEEPING MODE:
- Press key "SLEEP" enters into sleeping mode,
default value of fan speed is low.
- When sleeping mode turns on, under cooling
mode, the first one hour later, setting tempera-
ture will go up 1ºC, the second one hour later,
setting temperature will go up another 1ºC, and
then keep the same.
- Sleeping mode is invalid under dehumidifying
and fan mode. Under water full, machine stand-
by and mode conversion, sleeping mode will be
cancelled.
COMPRESSOR PROTECTION:
- Three minutes after pressing on / restarting,
the compressor will start to operate.
PROTECTION OF THE WATER TANK:
- When the water level in the lower water plate
is below the warning level, the appliance will
notify you automatically.
- Please pour the water in the machine accor-
ding to the instructions in the chapter "water
drainage".
WATER DRAINAGE:
- When the inside of the water tank is full, the
indicator will light up on the display.
- The device enters the standby mode.
- Remove the plug to remove the water, turn the